Pause; Reprint; Apperr1; Apperr2 - Intermec PA30 User Manual

Chapter 2 — Using the PA30 in an Applicator

About PA30 Out Signals

38

Pause

Toggles between Pause mode and printing. Not supported by S-
Style.

Reprint

Reprints the last valid label.

Apperr1

Applicator error 1.

Apperr2

Applicator error 2.

Apperr3

Applicator error 3.

RTWINEXT

External input signal for the Ready-to-Work indicator, which you
can use to monitor the operational status of the entire system.
This section describes the PA30 out signals.
Note: Unless described otherwise, all out signals are asserted low
and de-asserted high.

Data Ready

Asserted when the PA30 is ready to receive a startprint signal and
execute the current print job. De-asserted when the print cycle
ends. Not supported by S-Style.

Endprint

Asserted during or after a print cycle. The endprint signal also
behaves differently depending on the applicator port endprint
mode. When the startprint signal is received, the endprint signal
may or may not be asserted.
There are five options to choose from:
• Off: Endprint signal is never asserted.
• Mode 1 (Z-Style)/Type 3 (S-Style): Asserted low during
print/feed cycle.
• Mode 2 (Z-Style)/Type 4 (S-Style): Asserted high during
print/feed cycle.
PA30 Print Engine User's Manual