Chapter 7 — Managing, Maintaining, and Troubleshooting the PA30
Cleaning the PA30
Cleaning the Label Stop Sensor
PA30 Print Engine User's Manual
Replacing the Printhead: After you pull the printhead out, disconnect
the cables.
8 Connect the cables to the new printhead.
9 Slide the printhead into the print mechanism and hook the
bracket hooks on the shaft. Make sure the cables are clear of
the shaft and that the bracket hooks are seated properly on the
shaft.
10 Turn the prithead lift lever clockwise to close the printhead.
The magnet on the pressure arm should engage the printhead.
11 Load media and ribbon.
12 Close the PA30 access door.
To clean the PA30, wipe external surfaces with a soft cloth
slightly dampened with water or a mild detergent.
• Always remove the power cord before cleaning the PA30.
• Do not spray the PA30 with water or any other fluids.
• Do not use sharp tools to remove stuck labels.
If the PA30 starts to feed out labels unexpectedly, there may be a
problem with the label stop sensor.
103