Handling External Applicator Errors; Handling Internal System Errors; Error Messages; Errnoapp - Intermec PA30 User Manual

Error Messages

Message:
Cause:
Error Number:
Message:
PA30 Print Engine User's Manual
Chapter 2 — Using the PA30 in an Applicator
• when the PA30 is idle.
• when the PA30 is waiting for a startprint signal during the
execution of a printfeed command.
The PA30 prints only one label at a time.

Handling External Applicator Errors

The external applicator error in signals (
, ) should be asserted when external applicator
APPERR3 RTWINEXT
errors occur. When one of these signals is detected, an associated
event is activated in the System Health Monitor (SHM). When
the issue causing the error has been resolved and the error signals
are de-asserted, the events are deactivated in the SHM.

Handling Internal System Errors

When a system error occurs that activates an event in the SHM,
the "service required" signal is asserted. The external RTW out
signal can be de-asserted, depending on the current print engine
RTW setting.
When any of these errors occur, the appropriate out signal
(including the error) is asserted:
• Ribbon low
• Ribbon out
• Media low
• Media out
• RFID tag error
For more information on error messages, see
Ready-to-Work Indicator Descriptions" on page 110.

ERRNOAPP

Operation not allowed. Applicator Port disabled.
Application sent an applicator port command to the PA30 and
the applicator port is disabled.
88

ERRAPP

Operation not allowed. Applicator Port enabled.
, ,
APPERR1 APPERR2
"Error Message and
45