Intermec PA30 User Manual page 79

PA30 Print Engine User's Manual
Chapter 4 — Configuring Print Engine and Media Settings
3 For each alert you want to configure:
• Choose enabled or disabled from the Setting list for that
alert.
• Enter a value for the delay repeat in the Delay Repeat
entry field.
• Choose seconds or occurrences from the Delay unit
drop-down list.
• (Optional) Change the default alert message text in the
Message entry field.
4 Choose a notification method from the Notify with drop-
down list:
• Choose trap to send the mail notification to the SNMP
trap specified in SNMP settings. For more information,
see "Using Simple Network Management Protocol" on
page 99.
• Choose mail to send the notification to the E-mail address
specified in mail settings. For more information, see
"Configuring Mail Settings" on page 68.
• Choose trap and mail to send the notification to both the
SNMP trap and the E-mail address.
5 Click Submit Setup. The changes are saved.
Alert Message Descriptions
Message Sent When
Label Not Taken Printed label is not taken from the printer.
Requires the optional label taken sensor (LTS)
and applies to label and ticket media types.
Cutter Error Label cutter error occurs.
Head Lifted Print job is sent to the printer while the printhead
is lifted.
Out of Ribbon Thermal transfer ribbon is selected and the
printer is out of ribbon.
Out of Paper Printer is out of media.
Ribbon Low Diameter of the remaining roll of ribbon is lower
than the value specified in the Media
configuration screen.
67