Intermec PA30 User Manual page 28

Chapter 1 — Learning About the PA30
16
Opening the Printhead and Pinch Rollers
4 Remove empty cores from the media supply hub and the liner
takeup hub on the applicator.
5 Fit a new roll of media on the media supply hub.
6 Route the media under the slack absorber and towards the
print mechanism. You can rotate the slack absorber for better
access, or snap-lock it in open position.
7 Route the media through the print mechanism. Be sure to
keep the inner edge of the media as close to the back wall of
the PA30 as possible.
PA30 Print Engine User's Manual