Server Technology PRO2 Switched POPS C2WG12BM User Manual page 49

Notes:
• The ST Eye mobile app and the Bluetooth module may not be included with the PRO2.
• Learn more about the Bluetooth monitoring solution (for either Android or iOS) at Server Technology's
Technical Notes page
System > Branches
The Branches page provides the Branch Current Monitoring feature of the PRO2 to support up to six branches to
measure, report, and alert (in Amps) per branch circuit for breaker and fuse errors.
The Branches pages allows setting multiple load levels for low/high warning/alarm values (A) for branch current
thresholds, plus threshold hysteresis (A).
The page also sets sets SNMP Trap and Email notifications for branch events.
For dynamic monitoring of branch status and current, see the separate Monitoring > Branches page.
About the branches:
Branch names are not user-defined and cannot be changed.
•
Branch values affect the setting on the OCP – if an OCP is connected to the PRO2. Not all PRO2 units will
•
have an OCP; therefore, branch threshold range values will be affected by changing the current capacity
on the OCP.
To configure branch settings:
1. For each branch listed on the page, check (or uncheck) the SNMP Trap Notifications and/or Email
Notifications checkboxes to enable (or disable) branch event notification for a specific branch.
2. Click Apply.
Using the Web Interface
http://www.servertech.com/support/technical_library/technical_notes/
Smart PRO2 – User Guide
•
49