Server Technology PRO2 Switched POPS C2WG12BM User Manual page 159

set ldapgroup
Command Syntax
Parameters
Sub-Parameters
Command Access
Using the Command Line Interface (CLI)
Sets configuration values for LDAP group access rights.
set ldapgroup access [admin }| admin | poweruser | user ] <groupname>
set ldapgroup sysmon [disabled | enabled] <groupname>
The set ldap group command uses the following parameters:
access Sets the access type of an LDAP group.
sysmon Sets system monitor access for an LDAP group.
The set ldap group command uses the following sub-parameter:
groupname Name of the LDAP group to change access rights. 0-32 characters.
Admin level only
Smart PRO2 – User Guide
•
159