set ipv4, set ipv6
Command Syntax
Parameters
Command Access
Using the Command Line Interface (CLI)
Sets IPv4 and IPv6 configuration values.
set ipv4 address <ipv4 address>
set ipv4 gateway <ipv4 address>
set ipv4 subnet <ipv4 address>
set ipv6 address <ipv6 address>
set ipv6 gateway <ipv6 address>
set ipv6 prefix <ipv6 CIDR prefix>
The set ipv4 and set ipv6 commands use the following parameters:
Ipv4 address
Uses the format of XXX.XXX.XXX.XXX, where XXX=0-255.
Ipv6 address
Uses the format of XXX.XXX.XXX.XXX.XXX.XXX.XXX.XXX, where
XXXX=0-0xFFFF.
Ipv6 CIDR prefix
Uses the format of /0-64.
Admin level only; no access in Demo mode
Smart PRO2 – User Guide
•
157
Need help?
Do you have a question about the PRO2 Switched POPS C2WG12BM and is the answer not in the manual?