Server Technology PRO2 Switched POPS C2WG12BM User Manual page 103

4. To enable Daylight Saving Time (DST), check the Enable box.
5. From the DST Start/End drop-down menus, set the start/end date/time options.
6. Click Apply.
Network > Syslog
The Syslog page supports RFC3164 and RFC5424 compliance and the configuration for standard message
logging to enable offline storage and viewing of firmware log messages and system events.
To configure the Syslog server:
1. Host 1/Host2: Set the Syslog server address by typing the hostname/IP address in the Host1 and/or Host2
field(s). Both IPv4 and IPv6 IP address formats are allowed.
2. Port: When Syslog support is enabled, the Syslog server responds to requests on the default Syslog port
number 514 as displayed on the page. If necessary, edit the port number.
3. Debug Messaging: To enable debug messaging in the Syslog debug log, check the Enable box.
4. Protocol: From the drop-down menu, select the RFC protocol that determines behavior of the Syslog server
and message transmission
5. Click Apply.
Using the Web Interface
Smart PRO2 – User Guide
•
103