Set Email - Server Technology PRO2 Switched POPS C2WG12BM User Manual

set email

Command Syntax
Parameters
Using the Command Line Interface (CLI)
Sets email configuration values.
set email auth [disabled | enabled]
set email config [disabled | enabled]
set email [disabled | enabled]
set email event [disabled | enabled]
set email fromaddr <email addr>
set email smtp authtype [any | crammd5 | digestmd5 | login | plain | none]
set email smtp host <hostname>
set email smtp password <password>
set email smtp port <port>
set email smtp usefromaddr
set email smtp username <user name>
set email smtp useusername
set email test
set email toaddr1 <email addr>
set email toaddr2 <email addr>
set email trendfiles [disabled | enabled]
set email usesubjloc
set email usesubjdef
The set email command uses the following parameters:
auth Sets if authentication log messages are relayed by email
config Sets if configuration log messages are relayed by email.
event Sets if event log messages are relayed by email.
fromaddr Sets the email address the messages are relayed from.
0-48 characters.
authtype Sets the type of authentication to use when logging into the relay SMTP
server.
host Sets the host where the relay SMTP server is located.
0-63 characters.
password Sets the password for logging into the relay SMTP server
0-32 characters.
port Sets the port number for the relay SMTP server, 1-65535 (default 25).
toaddr1 Sets the first address to send email messages to. 0-48 characters.
toaddr2 Sets the second address to send email messages to. 0-48 characters.
trendfiles Sets the preference to have new trending report files sent out daily to
both "toaddrr" addresses at midnight.
userfromaddr Sets to log into the relay SMTP server using the from address.
Smart PRO2 – User Guide
•
153