Download Print this page

Server Technology PRO2 Switched POPS C2WG12BM User Manual page 152

Advertisement

set dhcp
Command Syntax
Parameters
Sub-Parameters
Command Access
set dns
Command Syntax
Parameters
Command Access
Using the Command Line Interface (CLI)
Sets DHCP configuration values.
set dhcp [disabled | enabled]
set dhcp fqdn [disabled | enabled]
set dhcp fqdn name <name>
set dhcp staticfallback [disabled | enabled]
set dhcp bootdelay [disabled | enabled]
The set dhcp command uses the following parameters:
fqdn
Fully-qualified domain name (FQDN).
staticfallback
Falls back to static IP address if DHCP fails.
Note: The staticfallback option does not apply when WLAN is
enabled.
bootdelay
Delays system boot by 100 seconds.
The set dhcp command uses the following sub-parameter:
name
FQDN name. 0-63 characters.
Admin level only
Sets domain name system (DNS) server configuration values.
set dns [primary | secondary] <ipv4/ipv6>
The set dns command uses the following parameters:
primary
Sets the first DNS server. 0-46 characters.
secondary
Sets the secondary DNS server. 0-46 characters.
Admin level only; no access in Demo mode
Smart PRO2 – User Guide
152

Advertisement

loading
Need help?

Need help?

Do you have a question about the PRO2 Switched POPS C2WG12BM and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Switched pro2Pro2 smart/switched c2w48cePro1 switched pops c1wg-24vd/yPro2 hdotPro2 switched pops