Server Technology PRO2 Switched POPS C2WG12BM User Manual page 173

Sub-Parameters
Command Access
set user
Command Syntax
Parameters
Sub-Parameters
Command Access
set wlan
Description :
Sets the wireless network configuration.
Command Syntax:
set wlan [disabled | enabled]
set wlan bssid <ap bssid>
set wlan key <ap key>
set wlan mac <mac address>
set wlan security [open | wep-open | wep-shared | wpapsk-aes | wpapsk-tkip | wpapsk-tkipaes |
set wlan ssid <ap ssid>
Command Access:
Admin level only; wireless module installed.
Using the Command Line Interface (CLI)
onutility Value of the OID when the UPS is in an "on utility" state. 1-65535.
port Port number for polling the UPS by SNMP. 1-65535 (default 161).
type Sets the type of the UPS; sets default commstr, oidspoll, onbattery,
onutility, and port. 1-11.
The set ups command uses the following sub-parameter:
oid The OID string with sequences of a dot and a number. 1-65535.
Admin level only
Sets configuration values for local user access rights.
set user access [admin | poweruser | user ] <username>
set user password <username> {password} {verify password}
set user sysmon [disabled | enabled] <username>
The set user command uses the following parameters:
access
Sets the access type of a local user.
password Sets the password for a local user.
sysmon Sets system monitor access for a local user.
The set user command uses the following sub-parameter:
username The ID of the local user to change access rights. 0-32 characters.
Admin level only
wpa2psk-aes | wpa2psk-tkip | wpa2psk-tkipaes]
Smart PRO2 – User Guide
•
173