Set Location - Server Technology PRO2 Switched POPS C2WG12BM User Manual

set line
Command Syntax
Parameters
Sub-Parameters
Command Access

set location

Command Syntax
Parameters
Command Access
Using the Command Line Interface (CLI)
Sets line configuration values.
set line email [disabled | enabled] <name | id | ALL>
set line load [alarmhi | alarmlo | warnhi | warnlo] <name | id | ALL> <value>
set line load hyst <value>
set line snmpt [disabled | enabled] <name | id | ALL>
The set line command uses the following parameters:
Email Email notification for line events.
Hyst Hysteresis between event state and recovery.
Load Current load for a line. min = 0A, max (current limit) in show lines
command, hyst 0.0-10.0A (default 1.0A).
SNMPT SNMP trap notifications for line events.
The set line command uses the following sub-parameters:
alarmhi High alarm value.
alarmlo Low alarm value.
warnhi High warning alarm.
warnlo Low warning alarm.
min <= alarmlo <= warnlo <= warnhi <= alarmhi <= max
Admin level only
Sets the system location string.
set location <location string>
The set location command uses the following parameter:
location string Location string text for system location. 0-63 characters.
Admin level only
Smart PRO2 – User Guide
•
160