Environmental Monitor (EMCU) Status
If an EMCU is connected to the PRO2, the Sensors pages will also include monitoring of water, contact closures,
and analog-to-digital (ADC) sensors.
What to look for:
The operating status of all sensors should be Normal and operating within defined thresholds. View the color-coded
graph showing current operating range within thresholds for the ADC.
Water and contact closure sensors can have either Normal or Alarm status – there are no other states or value
ranges.
The ADC sensors can be configured at Configuration > System > Sensors
Monitoring > UPS
The UPS page identifies each UPS device connected to the PRO2 unit, displaying hostname/IP address and UPS
status.
What to look for:
Monitoring page will be blank if a UPS has not been connected to, and configured for, the PRO2. After connecting a
UPS to the unit, configure the UPS and the lines to be powered by the UPS at Configuration > System > UPS.
Smart PRO2 – User Guide
Using the Web Interface
•
46
Need help?
Do you have a question about the PRO2 Switched POPS C2WG12BM and is the answer not in the manual?