About Snmp Versions - Server Technology PRO2 Switched POPS C2WG12BM User Manual

Network > SNMP
The SNMP page provides the protocol and agent configuration options for SNMP support.

About SNMP Versions

The firmware supports SNMP v1, v2c, and v3.
•
SNMP version 3 supports authentication and encryption on a per user basis. Authentication types are None
•
and MD5. Encryption types are None and DES. If you use authentication, you must use encryption.
Two SNMPv3 users are supported: one user with read-write (RW) access, and one user with read-Only
•
(RO) access Both users have the same configuration parameters, and you can configure each user
independently.
SNMPv2c and SNMPv3 can be enabled or disabled independently. You can have SNMPv2 and/or
•
SNMPv3, or none.
To configure the SNMP v2 agent:
1. Check (or uncheck) the Enable checkbox to enable/disable SNMP v2 support.
2. GET community (RO): Community strings for GET commands.
3. SET community (RW): Community strings for SET commands.
4. Click Apply.
Note: The default for SNMP support is Enabled. When Server Technology products are shipped, the
default SNMP configuration for the GET community string is set to "public" and the SET community
string is left blank.
Using the Web Interface
Smart PRO2 – User Guide
•
100