Setting The Hold Function; Preparation - Omron ZX2-LDA41 User Manual

Setting the Hold Function

Hold:
The hold function holds any values during the measurement period (sampling period),
and outputs these values at the end of measurement.
Procedure for setting up hold
Set to the MENU mode
Hold conditions setting
Self-trigger setting
When SELF U/SELF D is selected
Trigger level setting
Return to RUN mode
Setting completed
1
Set to the MENU mode
Button
Display
Operation
Hold down for
3 seconds
Press to display.
ZX2 User's Manual
Description of Operation
Hold down the
Lit
three seconds to switch to the
MENU mode.
Press the button to display
.
Press the button to set the
display to to set display of
the detail menu.
Press the button to apply
the setting.
Setting channels used when
connecting multiple units: Each CH
Explanation of
Selection Menu
button for
* This step is not required if
detail menu display is
already set to ON in the
MENU mode.

Setting the Hold Function

CONTENTS
INTRODUCTION

PREPARATION

FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
93