Using The Xds Remote Display; Using The Visitor Screen - Philips IntelliVue X2 Instructions For Use Manual

Using the XDS Remote Display

Changing a Screen's Content
If you do not want to change the entire Screen content, but only some parts of it, you can substitute
individual waves, numerics, or trends. Be aware that these changes cannot be stored permanently in
Monitoring Mode.
To change the selection of elements on a Screen,
Select the element you want to change. For example, touch the wave to enter the wave setup menu,
1
or touch the numeric to enter the numeric setup menu.
From the menu that appears, select Change Wave or Change Numeric, and then select the
2
wave or numeric you want.
In the Change Screen menu, the
changed Screen is shown linked to the
original Screen and marked with an
asterisk.
Up to three modified Screens can be
accessed via the Change Screen
menu.
To recall Screens, select the name of the
Screen in the Change Screen menu
After a patient discharge, the monitor's
default Screen is shown. Modified Screens
are still available in the
Change Screen menu.
If the monitor is switched off and then on again, modified Screens are erased from the monitor's
memory and cannot be recalled. If a modified Screen was the last active Screen when the monitor was
switched off, it is retained (unless Automat. Default is set to Yes in Configuration Mode).
Using the XDS Remote Display
Using the IntelliVue XDS solution it is possible to view an independent monitor screen on an external
display. The XDS solution consists of a medical grade PC-based hardware platform, XDS application
software and the XDS connectivity option on the monitor. Depending on the configuration you can
also operate the monitor from the external display. The XDS must be connected to the same Local
Area Network (LAN) as the monitor.
It is also possible to use an existing PC, connected to the same LAN, to host the XDS Application
software.
For more details, including limitations and restrictions, refer to the Instructions for Use for the XDS
Application.

Using the Visitor Screen

If a visitor Screen is configured for your monitor, you can use it to clear the screen of all waves and
numerics but continue to monitor the patient with active alarms and trend storage at the bedside and
Information Center. You can change the name of the visitor Screen in Configuration Mode.
To activate this Screen,
Change Screen
1 Wave B
1 Big Wave
Vital Signs B
2 Waves A
2 Waves B
2 Basic Operation
25