Philips IntelliVue X2 Instructions For Use Manual page 267

Multi-measurement module
Hide thumbs Also See for IntelliVue X2:
Table of Contents

Advertisement

Measurement Specifications
ECG/Arrhythmia/ST Performance Specifications
Bandwidth
when the ECG is
transmitted from a
telemetry device via short
range radio
Differential Input Impedance
Common Mode Rejection Ratio
Electrode Offset Potential Tolerance
Auxiliary Current
(Leads off Detection)
Input Signal Range
ECG/Arrhythmia/ST/QT
Alarm Specifications
HR
Extreme Tachy
Extreme Brady
Run PVCs
PVCs Rate
Vent Tach HR
Vent Tach Run
Vent Rhythm Run
SVT HR
SVT Run
ST High
ST Low
QTc High
ΔQTc High
ECG/Arrhythmia/ST Supplemental Information as required by AAMI EC11/13
Respiration Excitation Waveform
Noise Suppression
Diagnostic Mode
Adult/neo/pedi: 0.05 to 40 Hz
Extended
Neo/pedi: 0.5 to 40 Hz
Monitoring Mode
Monitoring Mode Adult: 0.5 to 40 Hz
Neo/pedi: 0.5 to 40 Hz
Filter Mode
Adult/neo/pedi: 0.5 to 20 Hz
>2 MΩ RA-LL leads (Resp)
>5 MΩ at all other leads (at 10 Hz including patient cable)
Diagnostic mode: >86 dB (with a 51 kΩ/47 nF imbalance).
Filter mode: >106 dB (with a 51 kΩ/47 nF imbalance).
±500 mV
Active electrode: <100 nA
Reference electrode: <900 nA
±5 mV
Range
15 to 300 bpm
maximum delay: 10 seconds according
to AAMI EC 13-1992 standard
Difference to high limit 0 to 50 bpm
Clamping at 150 to 300 bpm
Difference to low limit 0 to 50 bpm
Clamping at 15 to 100 bpm
2 PVCs
1 to 99 PVCs/minute
20 to 300 bpm
3 to 99 PVCs/minute
3 to 99 PVCs/minute
120 to 300 bpm
3 to 99 SV beats
-19.8 to +20 mm
-20 to +19.8 mm
200 ms to 800 ms
30 ms to 200 ms
Sinusoidal signal, 260 μA, 40.5 kHz
RL drive gain 44 dB max., max. voltage 1.8 Vrms
24 Specifications
Adjustment
Adult:1 bpm steps (15 to 40 bpm)
5 bpm steps (40 to 300 bpm)
Pedi/Neo:1 bpm steps (15 to 50 bpm)
5 bpm steps (50 to 300 bpm)
5 bpm steps
5 bpm steps
5 bpm steps
5 bpm steps
Not adjustable by user
1 PVC
5 bpm
1 PVC
1 PVC
5 bpm
1 SV beat
0.2 mm
0.2 mm
10 ms steps
10 ms steps
259

Advertisement

Table of Contents
loading

Table of Contents