Operating Modes - Philips IntelliVue X2 Instructions For Use Manual

Operating Modes

Operating Modes
When you switch the monitor on, it starts up in monitoring mode. To change to a different mode:
1
2
Your monitor has four operating modes. Some are passcode protected.
• Monitoring Mode: This is the normal, every day working mode that you use for monitoring
• Demonstration Mode: Passcode protected, this is for demonstration purposes only. You must not
• Configuration Mode: Passcode protected, this mode is for personnel trained in configuration tasks.
• Service Mode: Passcode protected, this is for trained service personnel.
When the monitor is in Demonstration Mode, Configuration Mode, or
Service Mode, this is indicated by a box with the mode name in the center
of the Screen and a symbol in the bottom right-hand corner. Select this
field to change to a different mode.
When an X2 is connected to a host monitor (Companion Mode is indicated):
• The X2 will adopt the operating mode of the host monitor:
• You cannot change the operating mode at the X2.
Standby Mode
Standby mode can be used when you want to temporarily interrupt monitoring.
To enter Standby mode,
1
2
The Standby screen looks like this:
To Purchase, Visit Avobus.com
Select the Main Setup menu.
Select Operating Modes and choose the mode you require.
patients. You can change elements such as alarm limits, patient category and so forth. When you
discharge the patient, these elements return to their default values. Changes can be stored
permanently only in Configuration Mode. You may see items, such as some menu options or the
altitude setting, that are visible but 'grayed out' so that you can neither select nor change them.
These are for your information and can be changed only in Configuration Mode.
change into Demonstration Mode during monitoring. In Demonstration Mode, all stored trend
information is deleted from the monitor's memory.
These tasks are described in the Configuration Guide. During installation the monitor is configured
for use in your environment. This configuration defines the default settings you work with when
you switch on, the number of waves you see and so forth.
Press the SmartKeys key
Either select the Monitor Standby SmartKey
Or select the Main Setup SmartKey, then select Monitor Standby.
or call 1-800-674-3655
.
2 Basic Operation
Config
23