Checking Battery Charge - Philips IntelliVue X2 Instructions For Use Manual

21 Using Batteries
TimeToEmpty tells you approximately how long you can continue to use the monitor with this
battery. Note that this time fluctuates depending on the system load (the display brightness and how
many measurements you carry out), the age of the battery, and the remaining capacity of the battery.
TimeToFull is shown in place of TimeToEmpty if the monitor is connected to mains power via
a host monitor or the M8023A external power supply, and tells you how much time is left until the
battery is charged to 90%. You can use the M8043A Smart Battery Charger to charge the batteries
externally.
Battery status/malfunction symbols: If a problem is detected with the battery, an INOP may be
issued, and the following symbols are displayed in the Battery Status window, where they may
be accompanied by a battery status message providing more details. Messages appear in the line where
TimeToFull/TimetoEmpty is shown. Symbols indicating critical situations are colored red.
Printing Battery Reports
To print the information in the Battery Status window on a connected printer,
1
2

Checking Battery Charge

♦
♦
224
To Purchase, Visit Avobus.com
Battery status symbols
battery is empty
battery not charging as the temperature is
above or below the specified range
battery requires maintenance
charging stopped to protect the battery
Select the battery status information on the Screen to open the Battery Status window
Select the Print Status pop-up key.
To check the charge status of a battery in a monitor, see the battery power gauge on the Screen or
select Main Setup -> Battery to enter the Battery Status window.
To check the charge status of a battery that is not connected to a monitor or battery charger, press
the black dot marked "PUSH" on the labeled side of the battery. The remaining charge is indicated
by four LEDs on the electronic fuel gauge directly above the dot. Each LED represents 25% of
charge. If all LEDs are lit, the battery is fully charged, if only one LED is lit, 25% or less charge is
left.
or call 1-800-674-3655
Checking Battery Charge
Battery malfunction symbols
(red) incompatible battery
(red) battery malfunction
(red) battery has no power left
(red) battery temperature too
high