Understanding Screens - Philips IntelliVue X2 Instructions For Use Manual

2 Basic Operation
The monitor enters Standby mode automatically after the End Case function is used to discharge a
patient. Standby suspends patient monitoring. All waves and numerics disappear from the display but
all settings and patient data information are retained. A special Standby screen is displayed.
If a patient location is entered at the Information Center, this will also be displayed on the Standby
screen (availability depends on Information Center revision, applies to stand-alone monitor only).
To resume monitoring,
Select anything on the screen or press any key.
♦
When the X2 is on (not in Standby) and is connected to a host monitor in Standby mode, the host
monitor will turn on.
When the X2 and the host monitor are both in Standby:
• Operating the X2 will make the host monitor turn on.
• The X2 will switch off when disconnected from the host monitor.
• If the host monitor loses AC mains power, the X2 will switch off.

Understanding Screens

Your monitor comes with a set of pre-configured Screens, optimized for common monitoring
scenarios. A Screen defines the overall selection, size and position of waves and numerics on the
monitor screen when you switch on. You can easily switch between different Screens during
monitoring. Screens do NOT affect alarm settings, patient category and so forth.
Switching to a Different Screen
To switch to a different Screen:
After closing any open menus or windows, press the Main Screen key to access the Change
1
Screens menu.
2 Choose the new Screen from the Change Screens menu.
24
STANDBY
Press any key or select any field on the screen
to resume monitoring
Understanding Screens