Stopping Reports Printouts; Setting Up Reports - Philips IntelliVue X2 Instructions For Use Manual

19 Printing Patient Reports
Report types
Vital Signs Report
Graphic Trends Report
ECG Reports
ST Map Report
Alarm Limits Report
Realtime Reports
Battery Report
Central Report A/B/C These are reports configured at the

Stopping Reports Printouts

To stop Reports printing, in the Reports menu, select
♦
– Delete Report to stop the current print job
– Delete All Repts to cancel all queued report printouts
– Scheduled Rep. to toggle to Off and switch off scheduled reports.

Setting Up Reports

ECG report layout and Auto Reports settings must be defined in Configuration Mode.
The content you define in the individual Setup Reports menus will be used in all reports of this
type: for example, if you set a print speed of 50 mm/sec in the ECG Reports menu, every ECG
report will be printed at this speed, irrespective of format.
Setting Up ECG Reports
The settings you choose in the ECG Reports menu apply for all ECG reports printed. To set up
ECG Reports,
1 Select Main Setup -> Reports -> ECG Reports. Note the report layout configured for
your monitor, either Internat. or Cabrera. This
and can only be changed in Configuration Mode.
Select ECG Gain and set the required ECG Gain to define how ECG waves will appear on the
2
ECG report printouts.
Select Speed and select the report print speed.
3
208
Report contents
depends on selected trend group, data
resolution, and period.
Depends on format selected
ST data in a transversal and/or horizontal
multiaxis diagram,
Graphic and numeric report of all
current alarm limits
Patient data and numerics, and either:
all displayed waves OR all measured
waves OR all measured RT waves
Battery serial number, information on
the currently-measured and potential
charge status of the battery
Information Center. Monitors connected
via the IntelliVue Instrument Telemetry
wireless network can have these reports
available.
Stopping Reports Printouts
How to start printing reports
In the Vital Signs window, select
In the Graphic Trends window, select
ECG Report
Select the
In the ST Map window, select
Alarm Limits
In the
Limits
Realtime Reports
Select the
configured
Battery Status
In the
Print Status
.
Main Setup
In the
Central Report A
setting is inactive ("grayed-out") in Monitoring Mode
Print
Print
SmartKeys, if configured
Print
.
Print
window, select
SmartKey, if
window, select
Reports
select then
B C
, or .