Table of Contents
Advertisement
15 Assigning Two Devices to One Patient
Telemetry Data Window
The measurements from the telemetry device are shown in the telemetry data window on the monitor
when there is no direct connection via short range radio link.
WARNING All data presented in the telemetry data window are delayed for several seconds.
If you need realtime data, for example for defibrillation, always use the monitor ECG instead of
telemetry. As long as the ECG is being measured with the telemetry device there will be no ECG signal
available at the ECG Sync Pulse output.
Direct Connection - Automatic Pairing
The following direct connections are possible:
• a TRx+4841A Intellivue Telemetry system transceiver connected via short range radio (SRR) link to
• an X2, declared as a telemetry device, and connected with an MSL cable to a monitor (MP20-90).
If a telemetry device is assigned to a monitor via a direct short range radio link, the monitor and the
telemetry device are automatically paired at the Information Center (if configured).
The measured data from the telemetry device — ECG and, if available, SpO
monitor screen and will be sent through the monitor to the Information Center. The ECG waves and
numerics appear in place of the monitor's own ECG, and SpO
measurement. When ECG is measured with the telemetry device there will be no Respiration
measurement derived.
WARNING
• When ECG is being measured with a telemetry device directly connected to the monitor, there will
• When a telemetry device is connected to the monitor, arrhythmia relearning is initiated, and again
182
To Purchase, Visit
Avobus.com
TELE INOP
** HR 140>120
SOME ECG ALRMS OFF
Delayed
HR
NBP
Auto 10 min
Sys.
an X2 with SRR capability.
be no ECG signal available at the ECG analog output or ECG Sync Pulse output and no
synchronization marks on the ECG wave. A No ECG Out message will appear in the ECG wave
channel.
when the telemetry device is disconnected.
or call
1-800-674-3655
* TELE ALARM
%SpO
T
2
etCO
2
imCO
2
How Can You Combine Devices?
Telemetry data
window
T— will appear on the
2
T is displayed as an additional
2
Advertisement
Table of Contents
Troubleshooting
