Paradyne CPX-1000 User Manual page 161

1000-A2-GB22-10
Step 5
Step 1
Step 2
Step 3
Step 4
Step 5
Step 1
Step 2
Step 3
Step 4
June 2005
Select a range of VPI values by using the less than (<) or greater
than (>) symbols from the drop-down list, then type a VPI value in
the text field.
Note
When the CRV/VCI/VPI value is not specified, All
(default) is used. The default indicates that the filter
only applies to the Interface Group or Network
Protection Group, regardless of the CRV/VCI/VPI
value.
Searching by the Interface Groups
Proceed as Steps 1 and 2 in
Select Interface Group from the drop-down list.
Type the Interface Group identifier, or select it from the drop-down
list.
Select a range of CRV by using the less than (<) or greater than (>)
symbols from the drop-down list.
Type a CRV number, or select it from the drop-down list.
Searching by the Hardware Model and Software Version
Proceed as Steps 1 and 2 in
Select HW Model from the drop-down list.
Type the model type, or select it from the drop-down list.
To further refine the search, select a software version from
the SW Version drop-down list, or leave the default as ALL to
select all software versions..
The software version(s) available in the list depends upon the
hardware model chosen.
9. IAD Profiles and IADs Provisioning
Searching IADs by Fields
Searching IADs by Fields
on page 9-49.
on page 9-49.
9-51