Upgrading The Software - Paradyne 6212 User Manual

Command Line Interface User's Guide

7.4 Upgrading the software

1. At the tftp prompt, type connect xxx.xxx.xxx.xx.
tftp> connect 172.16.4.12
connected to : 172.16.4.12
A message, "connected to : xxx.xxx.xxx.xxx," pops up if successful.
2. Type the transfer mode (binary or ascii).
tftp> binary
mode set to octet
A mode set to octet/netascii pops up.
3. Type get app when the file name is app, or type get app
software file name is app, you can also skip the file name by simply typing get app.
4. The tftp prompt pops up when the upgrade is successful. Below is an example of the software
upgrade procedures.
tftp> connect 172.16.4.16
connected to : 172.16.4.16
tftp> binary
mode set to octet
tftp> get app
tftp>
Sent 983040 bytes in 3 seconds
tftp>
126
to specify the name If the
1800-A2-GB20-00