Group3 - Paradyne 6212 User Manual

Command Line Interface User's Guide
If the bridge group was already set up, to configure the new group, delete the previous group by
using the bridge delete command, and then group the new interfaces you wish to the bridge.
The group and group3 commands are similar functions, but they group different number of
interfaces to the bridge.
COMMAND DESCRIPTION
interface_name
The name of an interface e.g. eth0, atm0... atm1 etc.
EXAMPLE
group eth0 atm0
The interfaces eth0 and atm0 are assigned to the bridge.
group eth0 atm0 –o atm1
The interfaces eth0, atm0, and atm1 are assigned to the bridge.
[1234 @ bridge]$ group eth0 atm1
Group Exist or Interface Busy
[1234 @ bridge]$ bridge delete
[1234 @ bridge]$ group eth0 atm0
[1234 @ bridge]$
Bridge group already exists. You must delete the group and then assign interfaces eth0 and atm0
to the bridge.
5.3.4

group3

group if if if
group if if if –o if
The group command assigns or groups three interfaces or four interfaces to the bridge. To group
three interfaces, use the command:
group if if
To group four interfaces, use the command
group if if –o if
56 1800-A2-GB20-00