Dhcp Server; Start - Paradyne 6212 User Manual

httpproxy -o –display
This option is used to display the configured information of httpproxy.
httpproxy -o -stat
This option is used to display the statistics of the connections passing through the httpproxy,
including inbound packets, outbound packets, inbound bytes, and outbound bytes.
httpproxy -o -auth[enable/disable]
This option is used to enable or disable the authentication module in httppproxy.

5.8 DHCP server

start

stop
subnet
host
lease
The dhcpserver commands configure the DHCP server function. They are put in the dhcpserver
directory. There is a pre-set DHCP subnet entry. To configure a new subnet
1. If it is run, use the stop command to stop it.
2. Use the subnet if delete command to delete the subnet.
3. Use the subnet add... command to configure the new subnet.
4. Use the start command to run the new subnet.
5.8.1 start
start
Starts the DHCP server. The subnet and host commands are used to configure DHCP server.
EXAMPLE
[1234 @ dhcpserver]$ start
DHCP Server started !!!
1800-A2-GB20-00
Command Line Interface User's Guide
87