1823 VoIP Gateway User's Guide
Chapter 7 Software Upgrade via FTP
Follow the steps below to upgrade the firmware version of the gateway via FTP.
The procedures below use IP address 192.168.1.101 for illustration. This is the default address of the
gateway.
STEP 1: Connect the gateway to a PC using the LAN cable. Set the PC to the same subnet as the
gateway (192.168.1.101).
STEP 2: Open a command prompt and enter the menu where the new firmware is installed:
Example: C:\Upgrade
STEP 3: Enter the command:
ftp 192.168.1.101 (the gateway's IP address)
STEP 4: At the User prompt type:
root (lowercase)
STEP 5: At the Password prompt type:
1234
STEP 6: After you see the message User Logged in, type:
Bin
STEP 7: After you see the message Type set to I, type:
ha
42
May 2005
1823-A2-GB20-00