Pppoadefault; List; Ipoa - Paradyne 6212 User Manual

Command Line Interface User's Guide
5.15.12

pppoadefault

pppoadefault <profile>
This command configures the specified profile as the default PPPoA connection. This profile
must be using "auto" mode. Out of all the profiles which are using the "auto" option, only one
can be run at a time. This command is used to specify that profile.
5.15.13

list

list <param>
This command displays the configurations of IPOA/BRIDGE/ROUTEDBRIDGE.
COMMAND DESCRIPTION
<param>
param can be bridge, routedbridge, or ipoa.
EXAMPLE
list bridge
This command displays Bridge parameters.
list routedbridge
This command displays Routed Bridge parameters.
list ipoa
This command displays IPoA parameters.
5.15.14

ipoa

ipoa <interface> <disable> <vpi> <vci> -o <default> <-nhp ipaddress>
ipoa <interface> <enable> <vpi> <vci> -o <-enc encapulation><default> <-nhp ipaddress>
<-vpn OUI vpnId>
This command configures the specified WAN interface to use IPoA, which is Classical IP over
ATM including Inverse ATM Arp. IPoA uses Inverse ATM Arp to get the peer IP address. The
Maximum Transfer Unit (MTU) for IPoA is 9182.
Note: In this case, if the peer does not support Inverse ATM Arp, then there will not be any
traffic flow. If the next hop (-nhp option) or default PVC is configured per IPoA, then it does not
use Inverse ATM Arp to get the peer IP address.
108 1800-A2-GB20-00