Routedbridge; 1483Mer - Paradyne 6212 User Manual

Command Line Interface User's Guide
5.15.15

routedbridge

routedbridge <interface> disable <vpi><vci>
routedbridge <interface> enable <vpi><vci> -o <-enc encapsulation> <-vpn OUIvpnId>
This command configures the specified WAN interface to use Routed Bridge which is RFC 2684
routing. Note the Maximum Transfer Unit (MTU) for the Routed Bridge is 9182.
COMMAND DESCRIPTION
interface
The name of the WAN interface. Typically this is 'atm7'.
enable
It enables this Routed Bridge interface.
disable
It disables this Routed Bridge interface.
<vpi> <vci >
These are the vpi, vci values on which the Routed Bridge has to be enabled/disabled. Vpi and vci
are assigned with the vcadd command. The showatmconn command can also be used to list the
current ATM connections with their respective vpi and vci values. (Note the vcadd and
showatmconn commands are located in the "atm" directory).
encapsulation
This specifies the encapsulation type. The possible values are 'llc' or 'vc' which represent
Logical Link Control or VC multiplexing respectively.
OUI vpnId
This enables VPN encapsulation. OUI is organizationally unique identifier. VpnId is VPN index.
EXAMPLE
routedbridge atm0 enable 0 100 –o -enc LLC
This command establishes a Routed Bridge connection on the WAN interface atm0. VPI, VCI
values 0, 100 is used for the ATM connection.. LLC encapsulation will be used.
routedbridge atm0 disable 0 100
This command disables the Routed Bridge connection.
5.15.16

1483mer

1483mer add port vpi vci encapsulation
110 1800-A2-GB20-00