Part 3 Delete The Pvc For Pppoa; Mer; Part 1 Create A New Vc; Part 2 Set The Pvc To Mer - Paradyne 6212 User Manual

Command Line Interface User's Guide
The pppoa command covers the basic settings for the PPPoA profile number, encapsulation
type, timeout period, authentication, user name, password, VPI, VCI, and NAT. You can
complete a PPPoA entry by typing this command that covers these basic settings. If you need a
complete setting, refer to the usage instruction above.
4. If the sndcp prompt pops up, a PVC 0/35 is successfully created for PPPoA mode.
3.5.3

PART 3 Delete the PVC for PPPoA

To delete the PVC set up for the PPPoA, you must delete the profile first under the sndcp
prompt. Secondly, delete the VC under the atm prompt. The following screen is an example.

3.6 MER

3.6.1

PART 1 Create a new VC

1. Type atm to enter the home prompt.
2. Type vcadd 0 35 ubr aal5
3. At the atm prompt, type home or exit to return to the home prompt.
3.6.2

PART 2 Set the PVC to MER

1. Return to the home prompt.
2. Type sndcp at the home prompt to enter the sndcp prompt.
36 1800-A2-GB20-00