Chapter 3 Quick Configuration; Rfc 1483 Bridged; Part 1 Create A Pvc; Part 2 Set The Pvc To Rfc 1483 Bridged - Paradyne 6212 User Manual

Chapter 3 Quick Configuration

This chapter describes how to configure the endpoint for the first time using the CLI. The
endpoint can work after these settings are complete.

3.1 RFC 1483 Bridged

To enable the bridging function of the endpoint, enter the sndcp directory from the prompt of
[1234 @ sndcp]$. In the sndcp directory, type bridge to enter the bridge directory.
3.1.1

PART 1 Create a PVC

1. Type atm at the home prompt to enter the atm directory.
2. Type vcadd 0 35 ubr aal5
3. At the atm prompt, type home or exit to return to the home prompt.
3.1.2

PART 2 Set the PVC to RFC 1483 Bridged

1. If there is no other RFC 1483 PVC set up, you must join the Ethernet interface to an ATM
interface (atm0 to atm7). Therefore, traffic can be transferred between the two interfaces. To
do this, type bridge to enter the bridge prompt. By factory default, interfaces Ethernet, atm7,
and wlan0 are joined to the bridge.
2. Type group eth0 atm7. In this case, atm7 is used. You can choose any other atm interface
you wish.
3. If the setup is successful, the bridge prompt pops up. If a PVC was set up other than the new
one, the message pops up: Group Exist or Interface Busy
You must delete the old PVC or PVCs to add the new group.
4. Under the bridge prompt, type pvc add atm7 0 35 llc. In this case, atm7 is used. You must
choose the atm interface that is joined to the bridge.
1800-A2-GB20-00
Command Line Interface User's Guide
29