Pppoestart; Pppoestop; Pppoelist; Pppoedel - Paradyne 6212 User Manual

This command configures the specified profile as the default PPPoE connection. This profile
must be using "auto" mode. Out of all the profiles which are using the "auto" option, only one
can be run at a time. This command is used to specify that profile. If the "pppoedefault"
command is not used, the first profile that used the "auto" option is used as the default.
5.15.3

pppoestart

pppoestart <Profile>
This command starts PPPoE given the specified profile. The profile is specified with an integer
(0, 1, 2...7). The profile was previously specified with the pppoe command.
5.15.4

pppoestop

pppoestop <Profile>
This command stops PPPoE given the specified profile. The profile is specified with an integer
(0, 1, 2). The profile was previously specified with the pppoe command.
5.15.5

pppoelist

pppoelist [-profile Profile]
This command displays the listing of all available free profiles. If -profile is not specified, this
command will display all the valid configured profiles.
5.15.6

pppoedel

pppoedel <profile> | all
This command deletes the specified profile. Profile is specified as a number (see pppoe
command). If all is specified the all profiles are deleted. This command only deletes inactive
profiles. If a profile is in use, it must be stopped before it can be deleted.
5.15.7

pppoa

pppoa <profile> -o <-if Interface> <-encap Encapsulation> <-restarttime Timeout> <-auth
Auth> <-myaddr IPAddr> <-peer PeerIPAddr> <-mtu MTU> <-mru MRU> <-user
Username> <-pass Password> <-vpi Vpi> <-vci Vci> <-nat [enable/disable]> <-netmask
mask> <-vpn OUI vpnId>
This command sets up a PPPoA profile. A PPPoA entry can be added by using the simplified
command as follows. Other part of the command is optional.
pppoe <profile> -o -if <interface> -user <user> -pass <password> -vpi <vpi> -vci <vci>
1800-A2-GB20-00
Command Line Interface User's Guide
105