Adsl; Setmode; Readcmv - Paradyne 6212 User Manual

This option shows the status of the DHCP Relay.

5.10 ADSL

Commands for setting and viewing ADSL parameters are in the "adsl" directory.
5.10.1

setmode

setmode <mode> [-trellis on/off] [-vendor default/broadcom/gsv/infineon/ti] -o [-bitswap
on/off]
This command sets the mode of the ADSL link to ANSI (T1.413), G.DMT, G.Lite, or multi-
mode. After executing this command, the configuration can be saved and the next time the
machine is rebooted, the mode will take effect.
COMMAND DESCRIPTION
<mode>
The mode may be ansi, gdmt, glite, or multi.
[-trellis on/off]
on enables the trellis code; off disables it.
-o [-bitswap on/off]
on enables bitswap; off disables it.
5.10.2

readcmv

readcmv <cmv_index> <offset>
The ADSL Configuration and Management Variables (CMV) can be read with the readcmv
command. The CMV variables are documented in "CMV Reference Manual". This command
will only provide meaningful results when the link is operational.
COMMAND DESCRIPTION
<cmv_index>
The cmv index may be one of the following values.
Note that they must be specified in uppercase: ADPT, CNTL, CODE, DIAG, DOPT, FLAG,
INFO, INTL, MASK, OPTN, PFCL, PFRX, PFTX, PSDM, RATE, RXDA, STAT, TEST,
TONE, TXDA, UOPT.
<offset>
This is a numeric value between 0 and 65535.
1800-A2-GB20-00
Command Line Interface User's Guide
91