Paradyne 1862 Quick Installation Instructions

Voip iad

Hide thumbs Also See for 1862:

Download this manual See also: User Manual

1862 VoIP IAD

Quick Installation Instructions

Document Number 1862-A2-GZ10-10

September 2005

Installation

➊

If you will use the USB port, install the USB driver:

– Insert the CD in your CD-ROM drive

– Browse to the USB Driver directory

– Start setup.exe

– Follow the instructions on your screen

➋

Connect the power adapter to the Power jack of the IAD,

then plug the power adapter into an AC wall outlet.

➌

Connect the FXS port of the IAD to your analog telephone with an RJ11 connector cable.

➍

Optionally, connect the USB port of the IAD to a free USB port on your PC with a standard USB cable.

➎

Alternatively, connect the LAN port of the IAD to your PC's Ethernet port, or to an Ethernet switch or hub, with an RJ45 cable.

➏

Connect the ADSL port to the wall outlet, a POTS splitter, or micro filter (consult your service provider), with an RJ11 connector cable.

➐

Turn on the power switch on the rear panel.

Using the Web Interface

Configuration of the Gateway is performed using its built-in web interface. To use the web interface, start your Internet browser. Type

the default IP address for the Gateway into the address field: http://192.168.1.1 Your PC must be on the same subnet as the Gateway.

The web interface requires a user name and password. The default username is root. The default password is b3gvoip for MGCP units

(Model Number 1862-A1-40x) and 1234 for SIP units (Model Number 1862-A1-42x). See the user's guide on the CD for details.

*1862-A2-GZ10-10*