Mer; Relay - Paradyne 6212 User Manual

This command configures the specified WAN interface to use 1483MER (MAC Encapsulation
Routing). The "mer" command is used to enable the configuration.
COMMAND DESCRIPTION
port
The MER interface name (mer0).
Vpi vci
These are the vpi, vci values on which the 1483 is configured. vpi,vci are assigned with the
vcadd command. The showatmconn command can also be used to list the current ATM
connections with their respective vpi and vci values. (Note the vcadd and showatmconn com-
mands are located in the "atm" directory). The vpi value is between 0 - 255. The vci value is
between 0 - 65535.
encapsulation
This specifies the encapsulation type. The possible values are 'llc' or 'vc' which represent
Logical Link Control or VC multiplexing respectively.
5.15.17

mer

mer enable | disable | delete | status
This enables, disables, deletes or gives status of the 1483MER configurations.
5.15.18

relay

relay
relay -o -client <-if interface> <-pvc vpi vci>
relay -o -server <-if interface> <-pvc vpi vci>
relay -o enable | disable
relay -o -display
The relay command configures and enables PPPoE relay.
COMMAND DESCRIPTION
-client <-if interface> <-pvc vpi vci>
This specifies the server interface for the PPPoE Relay. The PPPoE server is connected to this
interface. The interface may be ppp0, ppp1, ppp2, ppp3, ppp4, ppp5, ppp6, or ppp7.
-server <-if interface> <-pvc vpi vci>
This specifies the client interface for the PPPoE Relay. The PPPoE clients are connected to this
interface. Typically eth0 is specified.
1800-A2-GB20-00
Command Line Interface User's Guide
111