Chapter 1 Telnet Access; Setting A Common Ip Address - Paradyne 6212 User Manual

Command Line Interface User's Guide

Chapter 1 Telnet Access

The Command Line Interface (CLI) can be used to configure your endpoint device. Telnet is
used to access the CLI.
To Telnet to the device, you can either set your PC's IP address to the same domain as the
endpoint, or set the endpoint's IP address to the same domain as your PC. The default IP address
of the endpoint is 192.168.1.1.
The timeout period of the Telnet session is three minutes. If no command is entered for three
minutes, the Telnet session is terminated.

1.1 Setting a Common IP Address

To log on to the device using Telnet, your PC and the endpoint should both be on the same
network segment. You can either modify the IP address of your PC to the same domain of the
endpoint, or modify the IP address of the endpoint to the same domain as your PC.
You can modify the IP address of the endpoint by completing the following steps:
STEP 1: Enter a management tool (http or cli) for your endpoint
STEP 2: Change the IP address to the same domain as your workstation.
STEP 3: Save the settings to the flash and reboot the endpoint.
10 1800-A2-GB20-00