Setting up APPSOCKET
1. Press On Line on the Control Panel. Verify that the LED to the left of
the button is OUT.
2. Press the Menu button. The ON-LINE message will disappear and
TOP MENU should be displayed.
3. Press Next until <COMMUNICATIONS> appears on the Display
Panel and then press ENTER.
NOTE: The Mode options are not applicable for APPSOCKET. The
setting should always remain at AUTO SELECT.
TO CHANGE THE SETTINGS, FOLLOW THESE STEPS:
4. Press Next until <NETWORK SETUP> is displayed and then press
ENTER.
5. Press Next until <TCP/IP> is displayed and then press ENTER.
6. Press Next until <APPSOCKET> is displayed and then press
ENTER.
7. Press ENTER while <ENABLE> is displayed.
8. To enable APPSOCKET, press ENTER while <YES> is displayed.
9. To disable APPSOCKET, press Next until <NO> is displayed and
then press ENTER.
10. Press On Line. Verify that the LED to the left of this button switches
ON.
11. The APPSOCKET default settings are:
<APPSOCKET> = <ENABLE> = <YES>
<MODE> = <AUTOSELECT>
C O N N E C T I N G
T O
Y O U R
N E T W O R K
16