Formatting Your Hard Drive
Upon installation and prior to use, the optional Hard Drive requires
formatting using the following procedure:
1. Press On Line. Press Menu. <TOP MENU> message is displayed.
2. Press Next until <SERVICE> appears. Press Enter.
3. Press Next until <DISK SERVICES> is displayed. Press Enter.
4. Press Next until <FORMAT DISK> is displayed. Press Enter.
5. ARE YOU SURE? will be displayed. Press Enter.
6. Press Next until <YES> is displayed. Press Enter.
7. WAIT: FORMATTING HARD DISK is displayed while the hard
drive is being formatted. The time will vary, depending on the size of
the disk.
8. Exit the DISK SERVICES menu and put the printer ON-LINE.
9. Power the printer OFF and then ON. Verify hard disk information on
the startup page.
S Y S T E M
M A I N T E N A N C E
5