Xerox DocuPrint C55 Supplementary Manual page 146

10. From the Control Panel, CHECK the Mode entry. It must be set
to either PostScript or Auto-Select to correctly accept print jobs
from Macintosh computers.
11. From the Control Panel, RESET the printer and allow it to
process and go back ON-LINE.
12. If the above steps fail to fix the Network Print problem, contact
Xerox Customer Service.
LOCALTALK NETWORK STEPS:
1. VERIFY that the printer is plugged in, turned on, and connected
to an active Ethernet of LocalTalk network.
2. CHECK for, and correct, any error code conditions indicated on
the Control Panel display. A complete list of Error Codes, and
their definitions, are contained in this Technical Information
Guide in the chapter entitled Error Codes.
3. Verify the cable connection to the LocalTalk connector. (If you
are using PhoneNet, then make sure that ports on the PhoneNet
box are not empty. Empty ports on the PhoneNet connector
should have a terminator in it.)
4. Print out the DocuPrint Print Settings page. Details on this are
located in the chapter entitled Connecting to your Network.
Review the LocalTalk settings area of the Settings page. This
step verifies that LocalTalk is enabled and that the SLIC card I
properly installed. If the settings say "Not Installed", then this
indicates that the SLIC card is improperly installed, damaged, or
missing.
5. From the Control Panel, check the LocalTalk setting under the
Communications menu. Verify that LocalTalk is enabled. If
not, enable it in the Control Panel and reset the printer.
6. From the Control Panel, RESET the printer and allow it to
process and go back ON-LINE.
7. If the above steps fail to fix the Network Print problem, contact
Xerox Customer Service.
M A C I N T O S H 13