Ess Upgrade Process - Xerox DocuPrint C55 Supplementary Manual

S Y S T E M M A I N T E N A N C E 17

ESS Upgrade Process

When doing an upgrade the printer's Control Panel will go through several
stages.
As the printer starts to receive the file it will cycle through a "Processing",
"Waiting" messages.
After the file has been fully received the Control Panel will proceed to
"Upgrading, Please Wait..." and the upgrade process will begin.
After a few more minutes the Control Panel will now read "Initializing" ,
followed by "Printing". At this point a start up sheet will be printing.
The total process should take no more than 10 minutes over a network
connection, and no more that 20 minutes over the parallel port.
NOTE: It is important to not interrupt any part of the process after it has
been initiated. DO NOT TURN OFF THE PRINTER IN THE MIDDLE
OF AN UPGRADE. Doing so may require the printer to be serviced by a
Xerox authorized technician.
If you are concerned the process is taking too long, consult the General
Troubleshooting section, or call your Xerox Customer Support Center.