Tcp/Ip Protocol Configuration - Xerox DocuPrint C55 Supplementary Manual

Step-by-Step Setup for IBM TCP/IP for OS/2

TCP/IP Protocol Configuration

1. Acquire two IP addresses for use on your server and your
XEROX DocuPrint printer.
2. Install TCP/IP for OS/2. Remember to open Lan Adapter and
Protocol Support (LAPS/MPTS, etc) and configure the TCP/IP
protocol for your network adapter. (See your OS/2 documentation
for configuring network adapters for the TCP/IP protocol.)
3. Open (double-click) TCP/IP Configuration Object.
Click Printing TAB and enter the following:
REMOTE PRINT SERVER = Printer IP Address in 32-bit
dotted decimal notation (e.g. 127.0.0.0).
REMOTE PRINT SERVER'S PRINTER = ps (Enter
"ps", without quotes and in lowercase.)
MAXIMUM NUMBER OF LPD PORTS = Enter a
number between 2 and 64 inclusive.
FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click the
Autostart TAB. Highlight lprportd, then click Autostart
Service, Foreground Session, and Minimized.
Close the TCP/IP Configuration windows. Click SAVE,
then reply YES to Update CONFIG.SYS.
Shutdown your server/workstation and reboot.
NOTE: Once completed and you have rebooted, use the "ping "
command at an OS/2 Command Prompt to ping your
server/workstation's IP address. Repeat the ping command using your
DocuPrint printer's IP Address to confirm that your printer is
configured properly for using TCP/IP.
O S / 2 7