Remote Nic Configuration - Xerox DocuPrint C55 Supplementary Manual

Remote NIC Configuration

Maintenance mode example
To remotely configure the printer using Telnet, you can enter
"maintenance mode" by typing " !" at the Telnet console.
NOTE: You can get help while in maintenance mode by typing "h"
at the maintenance mode main menu.
NOTE: You MUST reset the NIC in the printer after going into
maintenance mode. You can do this in Telnet by using the R option.
The following is an example of entering "maintenance mode" :
1. At the Command prompt TYPE:
telnet XXX.XXX.XXX.XXX 2002 [ENTER]
2. The system will attempt to connect to the host. You will see:
Trying XXX.XXX.XXX.XXX
Connected to XXX.XXX.XXX.XXX
Escape character is '^]'
Telnet Console on
Type "S" to see current status
Type "!" to enter monitor
3. TYPE: ! [ENTER]
Warning: entering the monitor will lock out other Ethernet
access.
Type "yes" to continue.
4. TYPE: yes [ENTER]
Ready for command...
Command [D,E,I,L,N,R,Z] -->
U N I X 26