Windows Nt 4.0 Troubleshooting (Tcp/Ip); Procedure - Xerox DocuPrint C55 Supplementary Manual

Windows NT 4.0 Troubleshooting (TCP/IP)

Procedure

This troubleshooting section assumes:
Your printer was purchased with a network interface card (NIC)
installed OR you have installed, connected, and verified the
operation of the network interface card using the procedures
found in the Connecting to your Network chapter of this
document.
You have loaded a DocuPrint C55/C55mp PCL or PostScript
print driver.
You have printed and retained a current copy of the Print Settings
page.
1. Verify these items in the Network Settings area of the Print
Settings page:
Connector Type: is set for Auto OR the specific type that you
have used to connect the printer to your network.
2. Verify these items in the TCP/IP area of the Print Settings page:
IP Address Resolution: is set to DHCP, Static, or
RARP/BOOTP (depending on your network configuration).
Current IP Address: is set correctly (note this address if it is
assigned dynamically).
Subnet Mask: is set correctly (if used).
Default Gateway: is set correctly (if used).
LPR must be enabled to allow printing. Check the TFTP,
Appsocket, and Telnet settings and verify they are set as desired.
These settings are not critical to operation but provide some
security and usability features.
W I N D O W S 50