NetWare 4.1X (NDS) Print Server setup with
Setup Wizard
Procedure
The DocuPrint C55/C55mp printer defaults will, in most cases,
enable connection to Novell NetWare without adjustment.
NOTE: Token Ring ONLY - Speed and Source Routing must be set
to the correct values. (Defaults are 16 Mbits/SEC and Yes)
1. Review the Print Settings page and VERIFY the following
settings:
Ethernet or Token Ring (depending on NIC card) are
ENABLED.
Connector is set correctly for either BNC, RJ45, or DB9.
Auto is the Default and will probably work for most
applications.
Frame Type matches the frame type of the desired fileserver.
Mode is set to your desired PDL (PostScript or PCL5C) or to
Auto Select. You may wish to set Mode to the desired type if
only one PDL will be used.
Print Server Name. If this printer is unconfigured, the
default print server name is the letter 'X' followed by the last
six digits of the network card serial number.
2. Start the CentreWare DP application from your workstation. For
more detailed information about the operation of CentreWare DP
refer to the chapter entitled CentreWare DP Software
Instructions.
N O V E L L
N E T W A R E
S E T U P
11