Xerox DocuPrint C55 Supplementary Manual page 226

C E N T R E W A R E
PARALLEL TAB
This screen enables the use of check boxes to select or change parallel port
options as follows:
NOTE: Type and number of local ports may vary based on the printer
selected.
Enable Port Check this box to enable the parallel port of the printer.
Mode This drop-list allows the user to set the mode in which
the parallel port accepts print jobs. The following
modes are available:
AutoSelect – Allows the printer to select the mode in
which print jobs are accepted.
PostScript - The printer accepts PostScript without
binary. Use of this mode requires all binary
information to be encoded in ASCII.
PostScript TBCP (Tagged Binary Communications
Protocol) Mode - This mode uses special control
characters to enter and exit the binary mode, within a
PostScript job. This mode is the factory default.
PostScript Binary - This mode allows the sending of
binary data within a PostScript job.
Enables two-way communication with your printer
Bi-Directional
through the parallel port. Factory default: P1284 nibble
mode, IEEE standard. Allows the printer to send and
receive data/status.
D P S O F T W A R E I N S T R U C T I O N S 23