Static Addressing Setup
The printer is assigned a TCP/IP address by a network administrator. This
address is manually input to the printer. Perform the steps below:
1. Press the On Line button on the Control Panel. Be sure the light next
2. Press the Menu button. The ON-LINE message disappears and TOP
3. Press Next until <COMMUNICATIONS> appears on the Display
4. Press Next until <NETWORK SETUP> is displayed and then press
5. Press Next until <TCP/IP> is displayed and then press ENTER.
6. Press Next while <IP ADDRESS> is displayed and then press
7. With <IP Address Res> displayed, press ENTER.
8. Press Next until <Static> is displayed and then press ENTER.
9. Press ENTER while <SET IP ADDRESS> is displayed.
10. Press Next to increase the digit value. Press Previous to decrease
11. The Next button wraps around the display without setting the value if
12. Reset the Printer to have the new settings take effect.
C O N N E C T I N G
to it is OFF.
MENU is displayed.
Panel and then press ENTER.
ENTER.
ENTER.
the digit value. When each digit is correct, press the Select button to
move on to the next digit.
an error is made. After the complete IP address is displayed correctly,
press ENTER. The IP address is now set.
T O
Y O U R
N E T W O R K
13