Setting Up Appsocket; Printing A Configuration Sheet - Xerox PHASER 5400 Advanced Features And Troubleshooting Manual

3. Press Value Up or Value Down. You should see:
Default Gateway=
xxx.xxx.xxx.xxx
4. Press Value Up or Value Down to change the value of the character above the cursor.
The value is incremented or decremented by 1 each time the key is pressed. Holding
down Value Up or Value Down causes continuous scrolling through the values.
5. To change other characters in the Default Gateway address, press Item Up or Item
Down to scroll right or left respectively through the character string, then press Value
Up or Value Down to change the value of the character above the cursor (as in Step 4).
6. When you have completed setting the Default Gateway address, press Enter. You
should see:
Ethernet Menu
Default Gateway
Press On Line. You should see:
7.
Ready

Setting up AppSocket

To enable or disable the AppSocket protocol, perform the following steps:
1. Press Menu Up or Menu Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down until you see:
Ethernet Menu
AppSocket Enabl
Press Value Up or Value Down until you see:
3.
AppSocket Enabl=
or
On Off
4. Press Enter. You should see:
Ethernet Menu
AppSocket Enabl
5. Press On Line. You should see:
Ready

Printing a Configuration Sheet

It is important to print a Configuration Sheet from the printer to determine the current
network settings of your Phaser 5400 printer. The default settings enable all ports, which
are suitable for most applications. Refer to page 30 for step-by-step instructions on printing
a Configuration Sheet.
Note
If you change any settings, print another Configuration Sheet to verify that your
changes were made.
Advanced Features and Troubleshooting Manual
Networking
63