Quick Step (Os/2 Warp Server V 4.0); Quick Install Setup; Troubleshooting - Xerox DocuPrint C55 Supplementary Manual

Quick Step (OS/2 Warp Server v 4.0)

Quick Install Setup

Troubleshooting

To install and use your XEROX DocuPrint Color Printer in an IBM
Warp Server environment, you will need to perform several
administrative tasks in order to install the printer and configure your
server.
1. INSTALL NIC (Network Interface Card) – Token Ring must set
16/4Mbs.
2. NETWORK CABLE CONNECTION - Attach
RJ45/DB15/BNC.
3. PRINT SETTINGS PAGE - Print the Print Settings page from
the Control Panel.
4. TCP/IP & CABLE SETTINGS - TCP/IP enabled/Cable
Auto Select/RJ-45,etc.
5. CREATE OS/2 PRINTER OBJECT - Install/create printer
driver& printer and share.
6. TEST PRINT - Start LPRPORTD/LPRMON, ping printer, open
EPM and test print.
7. COLOR/PRINT QUALITY - Refer to the DocuPrint
C55/C55mp User Guide.
1. Reinstall NIC. Make sure lights are active.
2. Check cables/drops. Are they active?
3. Print Settings. Check Enabled=ON,
IPADDRESS=dhcp/bootp/static (make sure the IP Address
resolution is set properly. Use DHCP if your network uses a
DHCP server to assign IP addresses. Use RARP/BOOTP if your
network uses BOOTP to assign IP addresses, and use STATIC if
you wish to enter the IP address via the Control Panel).
4. Recheck RJ-45/BD-15/BNC. Recheck 16 or 4 Mbps.
O S / 2 5