Setting Up Appsocket - Xerox phaser 2135 Advanced Features And Troubleshooting Manual

Networking
Setting a TCP/IP Address
Your Phaser 2135 printer can be set up on a variety of TCP/ IP networks. There are several
ways in which your printer can be assigned a TCP/IP address depending on your network.
Static Addressing TCP/IP address is assigned manually by the System Administrator.
I
Dynamic Addressing BOOTP TCP/IP address is assigned automatically by the Server.
I
Dynamic Addressing DHCP (Dynamic Host Resolution Protocol) TCP/IP address is
I
assigned automatically by the Server.
For setting a TCP/IP address, refer to the Phaser 2135 Color Printer Quick Network Install
Guide. Determine which method is appropriate to use for your network and follow the
steps of the procedure.

Setting up AppSocket

To enable or disable the AppSocket protocol, perform the following steps:
1. Press Menu Up or Menu Down until you see:
2. Press Item Up or Item Down until you see:
3. Press Value Up or Value Down until you see:
4. Press Enter. You should see:
5. Press On Line. You should see:
110
Menus
Ethernet Menu
Ethernet Menu
AppSocket Enable
AppSocket Enable =
On or Off
Ethernet Menu
AppSocket Enable
Ready
Phaser Color Printer 2135